Hard Disk Monitoring

I just finished cloning a failing Toshiba HDD to a WDBNCE5000PNC-WRSN 500 GB sata ssd. When I booted the PC the health monitor on HD sentinel read 1%. So I figured it was a bad out-of-the-box drive.
So I got another and this time I put it on my bench machine before cloning and it too reads 1% health.

Any suggestions.

PLEASE UPDATE HARD DISK SENTINEL TO LATEST VERSION.

If an SSD works differently than previous models, provides health differently than expected, It is completely normal and expected that any software (or software version) released before that may not able to interpret it properly.

There is no need to re-post / re-open a topic, which already covered:

hdsentinel.com/forum/viewtopic.php?f=8&t=12497&p=17818