Hello,
is there an plan to support the new Adaptec Raid Line?
http://www.adaptec.com/de-de/products/series/7/#
Thx for the Info.
Regards Andreas
Adaptec 71605
-
hdsentinel
- Site Admin
- Posts: 3128
- Joined: 2008.07.27. 17:00
- Location: Hungary
- Contact:
Re: Adaptec 71605
Hi,
Thanks for your message and question.
To be honest, it was not yet tested.
If the new controller is compatible with the previous Adaptec controllers (in terms of detection of disk status information), it may be already supported by the latest versions, just like Adaptec 5xxx, 6xxx etc. controllers. If not, hopefully it can be supported as well in a future version - we'll do our best for that!
If you have such controller, please use Report -> Send test report to developer option as it would help development.
Thanks for your message and question.
To be honest, it was not yet tested.
If the new controller is compatible with the previous Adaptec controllers (in terms of detection of disk status information), it may be already supported by the latest versions, just like Adaptec 5xxx, 6xxx etc. controllers. If not, hopefully it can be supported as well in a future version - we'll do our best for that!
If you have such controller, please use Report -> Send test report to developer option as it would help development.
-
hdsentinel
- Site Admin
- Posts: 3128
- Joined: 2008.07.27. 17:00
- Location: Hungary
- Contact:
Re: Adaptec 71605
I sent e-mail long time ago, but in case you missed it, FYI: the latest version of Hard DIsk Sentinel (4.40) already supports Adaptec RAID 7 series controllers, for example the 71605, so the status of all hard disks / SSDs connected and configured as RAID array(s) are detected and displayed.