Windows commandline report equivalent to Linux NAS monitoring

[hmcfarlan2]

I set up NAS monitoring as outlined on this page for my Linux NAS:

https://www.forum.hdsentinel.com/how_to_monitor_network_attached_storage_nas_status.php

Is there an equivalent Windows commandline I can run to produce a report to also consume in the same way under "Configure NAS Monitoring"?

I found the DOS commandline version but it explicitly says it only works on "real" DOS not commandline under windows: https://www.hdsentinel.com/hard_disk_sentinel_dos.php

The exes I see in the folder that I tried running similar commands (-r, /r, /?, etc):

• HDSAction.exe - "external module with specific functions" according to https://hdsentinel.com/forum/viewtopic.php?p=14060&hilit=HDSAction.exe#p14060
• HDSCtrl.exe - seems to be only for a Windows service
• HDSentinel.exe - main GUI windowed app

These seem obviously not suited for this:

• harddisksentinelupdate.exe
• HDSentinelTray.exe
• unins000.exe

[hdsentinel]

No: as on Windows systems, you can install Hard Disk Sentinel to detect/diagnose, so there is no point in monitoring a (different) Windows PC this way, so there is no such / similar solution possible.

If you prefer to monitor Windows systems remotely from a central monitoring console, then Hard Disk Sentinel Enterprise package designed for that