Error code 1072 starting Repair

[rbcameron]

I tried to start a Repair test on an internal SATA drive today, and got these messages:

27/08/20 9:13:38 Sequential test, Disk: [1] 1863 GB F: WDC WD20EZRX-00D8PB0 [WD-WMC4M1631972] [Repair]
27/08/20 9:13:39 Test ID# detrd64.dll E: System Error. Code: 1072.
The specified service has been marked for deletion
27/08/20 9:13:39 ! Error: 5 Access is denied., Sector: 0

I can do a Read test on the drive, but (as you see) Repair fails.

[hdsentinel]

Sorry for the troubles. If I'm correct, you already have a Disk Repair test running on a different hard disk drive.

I'm afraid it is not possible to run Disk menu -> Surface test -> Disk Repair test on multiple drives at the same time: as you can see, while one of the test is running, the 2nd one can't start at all.

You can launch any number of other tests, eg. Disk menu -> Surface test -> Read test on multiple drives at the same time - but the Disk Repair test can only run on one disk drive at any given time.

[rbcameron]

Yes, that is exactly what was happening. Would it be possible for you to show a message that explains the exact reason for the conflict when this happens?

Thanks

- richard

[hdsentinel]

Thanks for the suggestion, yes, this may cause less troubles/confusion.