Hard Disk Monitoring

version 5 window 64 bit

What is the best temperature window between what C and what C

How low should disk health eb before you set yourself to get a warning

But this is not required at all

I require it. One of my disks overheats very quickly . It is an external which sits on tower and sata connects. I need to be able to stop it when finished with it. It is too much to have to plug out each time

Is there any way to control disks individually? To have one power down while the others run?

This disk is now overheating very quicky. It is an external e sata 500GB and sits on top of the case on the outside. In two hours it has gone from 18 degrees to 42 degrees and hardly been used. So I have to unplug it now. Should I be looking to replace it. it is back up for photos and movies so I do...

Just configure an alert which should be displayed: 1) On Configuration -> Message settings page, enable the "Display message on screen" option (and may disable the Send e-mail option if you want message to be displayed on the screen only). 2) Then on the Alerts page, enable one or more ev...

Thanks. How can one test the display message on screen option

What features are not available on the unregd version?

I cannot get email alert to send through hotmail. Hotmail is now outlook so using outlook serversas attached

Solved. Thanks

In the sound alert tab, whether I choose the Siren or the Notify the sound played when testing is just two pips?

Got it back to 100% performance and 99% health. Thanks

The slider on the left hand side of the GUI is very slow and goes from all the way up to all the way down? Is there any way not to show generic flash drives?

Here is an image after the repair. Thanks

hd_values.jpg Here is the result of the writes test which wiped the disk. I formatted it and it took about 10 hours for 500GB disk and said could not format all or some such expression. Would that be the bad sectors. Now it is blank and i want to correct the values befire using it again What do I c...

Here is a screenshot of the write test that wipes the disk. i had to wait until I had copied the content to another disk. I am formatting the disk now, is that OK? Should i have cleared the error-counter first or does it matter. Thanks for your time

Here is the result of the
Disk menu -> Surface test -> Read+write+read test refresh data area test

It says no new reallocated sectors. Does that mean there may be old reallocated sectors? It says WRITE in orange as it was flashing read/writes when i took screenshot

Thanks for your message and excuse me for the confusion. Yes, I must say it can happen - and not rare. I am not sure whta can happen? You mean the turn off if the pc is idle may look like spin up problems? Here are the other tests I did. I did all the tests that do not write over the disk. Do you t...

hd2go.jpg hd2go.jpg This is the report of an external disk.This disk https://www.medion.com/gb/service/_lightbox/handbuch_details.php?did=6092 i think it turns off if the pc is idle. Could that explain it There are 214 bad sectors on the disk surface. The contents of these sectors were moved to the...